Hello team,

I am trying to figure out pipe network operation.

I am trying to set the specs as:

- Input 1x pipe at 25 Deg. C, 200L/min and 5.5 Barg.

- Output 2x pipe at 25 Deg.C, 100L/min and whatever the calculated pressure should be.

- 2x pipes with exact same specs (one leading to each output).

The network cannot perform this calculation and instead either comes up wtih errors, OR the outlet flows are less than 1L/min each. I'm not sure what is going on here but there is either a problem with the program or my configuration.

I have tried everything, pressure basis, volume, estimating pressure drops (from manual calcs) etc, yet the networks till fails to come up with any real answer.

Can someone please give me a bit of aid?

Jonathan