0
Water saturation model not running

Hi,

I´m tryin to model natural gas saturated with water, using a mixer and a separator, and then adjusting mass flow rate until vapor fraction is 1.0, however I'm not getting it to start solving since it shows the following error:

"water: index was outside the bounds of the array"

What does that mean? What am I doing wrong, since this should be a fair simple model.

Attached is the file.

Thank you in advance!


DWSIM 02-06-21, 8:27 p.m. diego.garcia
0
What property package are you using? SRK should work fine with this model. Please change your thermo property package to SRK and try running the simulaton.
21-06-21, 11:53 a.m. Priyam_Nayak


Log-in to answer to this question.