

boundary conditions
I have a surface/wall (10cmx10cm), where I want to apply varied pressure during the simulation on a small area of the surface say (10mm x 10mm). Is this possible?
Can you guide me to do it?
OpenFOAM


Yes, you can do this using the codedFixedValue boundary condition on the newer versions of OpenFOAM. An example of codedFixedValue can be found in the below link.
https://cfd-training.com/2018/05/07/non-uniform-inlet-profil-with-codedfixedvalue/
Regards,
Ashley
Thanks for the information, I will try to figure it out for more. Keep sharing such informative post keep suggesting such post.
10-03-21, 11:05 a.m. Moises
Login to add comment