0
i am not able to connect wire to components

As i place component on the schematic ,the component will placed in between 2 dot of grid due to which i am not able connect wire because wire will connect to those components whose terminal in on the grid dot

here is screenshot of schematic window


eSim 19-09-19, 3:44 p.m. BUNTYJATT
0

The grid is quite irrelevant to placing wires. Notice the two bubble-like shapes on the end of the resistors? That's the point you are supposed to start a wire connection or end it, depends on your design.

19-09-19, 4:47 p.m. Saurabhb17
This is the problem, I am not able to connect or start wire or end wire from the terminal
Reason behind the irrelevant grid ?

19-09-19, 5:13 p.m. BUNTYJATT
How to correct it to make connection

19-09-19, 5:14 p.m. BUNTYJATT
select the place wire tool -> click on the bubble-like shapes on the end of the resistors and drag the cursor to other end of another resistor and click. You may want to watch the tutorial "Simulating an Astable Multivibrator". There we have shown common mistakes also. Hope it clarifies your doubt

19-09-19, 5:25 p.m. Saurabhb17
You can exactly place the component on the dot by moving it. Take the cursor to the component and press M , move it to the dot to place. It will be connected.

20-09-19, 1:29 p.m. Devibhagavathi

i am having the same problem. the end of my components are not going to the end of the wire and not the end of the wire is being placed to the end of the components

 


27-04-21, 9:47 p.m. abhinit41

Login to add comment


Log-in to answer to this question.